MANIPULATOR STYLUS

Non-marking

THIS STYLUS PROVIDES A REVOLUTIONARY GRIP ON THIN AND DELICATE COMPONENTS

Utra-light and easy to handle, this stylus enables you to manipulate all sorts of components. It will be particularly welcome for picking up delicate components that are hard to grip with tweezers. Since it does not exert any clamping pressure, you can be sure that this tool will not scratch or deform the most delicate components.

It comprises a Ø 3 and Ø 6 end-piece made from a soft, adhesive material, without leaving any marks on the contact surfaces. This adhesive material will retain any dust present on the components. Simply run under clean water or clean using an alcohol-soaked cloth, and then dry in the open air, to restore the optimum adhesion of these end-pieces.

In case of wear, it is relatively easy to turn the end-pieces around, or replace them with new ones, so that you can restore optimal working conditions.

There are caps for keeping the end-pieces clean when the stylus is not in use.

The end-piece size is marked visually.

Reference :

H491000

Size :

With caps: Ø 10 x 155 mm

Without caps: Ø 10 x 110 mm

Weight :

15 gr

Technical specifications :

• 2 end-pieces : Ø 3 / Ø 6 mm

• End-piece material:

o Polyuréthane

o Hardness 15 Shore A

APPLICATIONS:

GRIPPING COMPONENTS:

The Ø3 end-piece on the stylus is used for picking up small, lightweight and very delicate components

The Ø6 end-piece on the stylus is used for picking up relatively large and heavycomponents. However, the contact surface must be approximately equal to that on the end-piece

REMOVING DUST / PARTICLES:

This tool makes removing dust easy.

Thanks to its cleanability, it has a long lifetime, hence it can replace disposable products.